How do you change the draw length on a Mathews sq2?

How do you change the draw length on a Mathews sq2?

Rotate the adjustment wheels on the cam, one mark up to increase draw length or one mark down to decrease draw length. For example, if you wish to decrease the current draw length of the bow by 1 inch, and the cam is set to mark “C” or mark “3,” rotate the wheel to mark “B” or mark “2.”

How do you adjust the draw length on a Browning compound bow?

Use an Allen wrench to unscrew the draw length adjustment screw. Tighten the screw in the appropriate corresponding letter. For example, if the “A” setting is a 30-inch draw and you want the bow set to a 28-inch draw, move the draw length adjustment to the “C” position. The “D” position would indicate a 27-inch draw.

Which bows can be adjusted for draw length?

Adjustable cams allow the archer to adjust his or her draw length with the use of an hexagonal wrench without, in most cases, pressing the compound bow. Adjustable compound bow cams allow archers to adjust anywhere from 3 inches up to 13 inches depending on the compound bow.

How do you adjust the draw weight on a Mathews bow?

Draw weight adjustments are made using either a 3/16” or 7/32” Allen Wrench. Turn the limb bolt clockwise to increase the draw weight and counter clockwise to decrease the weight. Both limb bolts must be adjusted equally, or the bow may become out of tune/synchronization. The limb bolt should be snug.

Can you adjust draw length on Mathews VXR?

Both the VXR 28 and VXR 31.5 are powered by the award-winning, highly efficient and extremely accurate Crosscentric Cam system, producing speeds up to 344 fps. Its SwitchWeight Technology allows shooters to change peak draw length and draw weight in 5-pound increments via the cam’s module instead of changing limbs.

How do you change the draw length on a Mathews no Cam?

Simply remove the two allen screws that hold the module to the wheel and install your new module in it’s place. As noted earlier these modules can change both your draw length as well as your let-off, which will change your bow’s speed. The lower the let-off the faster the bow.

How do I measure my bow draw length?

To measure your draw length, stand with your back to a wall stretching your arms out against the wall. Measure the distance from the end of your middle finger to the end of your other middle finger, basically the length of both arms, hands and chest. This measurement, minus 15 then divided by 2, is your draw length.

Can you change draw length on vxr?

Proven accurate in the field, this revolutionary cam system, allows you to change draw length and peak draw weight into 5 pound increments with the simple change of a mod.