Why is my Razor electric scooter not working?
Check for loose connection(s) underneath the deck plate. If there are loose connection(s), reconnect them. If there are NO loose connection(s), replace reset button/power switch.
Why is my electric scooter not moving?
If your scooter does not work try to move the power switch or key switch between the “on” and “off” position several times. If you find that the switch is loose there may be a problem because of the switch. The problem with the switch can also be checked with the multimeter.
How do you reset a Razor electric scooter?
Turn power off; wait a few minutes & press reset button. The power switch should light up and scooter runs….Try the following:
- Check for loose connection(s) underneath the deck plate.
- If there are loose connection(s), reconnect them.
- If there are NO loose connection(s), replace reset button/power switch.
What does the reset button on a Razor scooter do?
The reset button (on the left side of the battery box) will automatically trip and turn off the power if the motor is overloaded.
What would cause a scooter not to start?
Check the Engine Ignition and Fuel System: In most cases, the problem with a scooter not starting but with power is caused by an issue with the engine; either a bad spark plug wire, bad plug or a fuel system problem. This is caused by a problem with the spark plug, spark plug wires, or the ignition coil.
Why does my Razor scooter just clicks?
Check for loose connection(s) underneath the deck plate. If connections are loose, reconnect them. Secure unit; turn power on & with NO weight on the unit, lift back end up & apply throttle. If rear wheel spins freely, replace the battery and/or charger.
How to troubleshoot a pocket mod electric scooter?
Page 1 POCKET MOD Electric Scooter Troubleshooting Guide Issue Symptom (s) Troubleshoot Result (s) Possible Solution (s) Replace fuse and correct riding Unit shut off while in use Remove battery/motor cover & check fuse Product Does Not Run Fuse burnt out conditions. (Refer to Pg 6 in Owners…
Why does my electric scooter not go after charging?
Check chain and rear wheel. If chain rotates but rear wheel does not move, replace the rear wheel assembly. Power switch light up. Scooter worked but will not go after charging. Secure unit; turn power on & with NO weight on the scooter, lift back end up and apply the throttle.
Where can I find replacement parts for my Pocket mod?
To find replacement parts visit the Replacement Parts page. Pocket Mod: What are the full product specifications? Brake:… Need Help?
What to do when your scooter won’t turn off?
Turn power off; wait a few minutes & press reset button. The power switch should light up and scooter runs. Do not exceed the weight limit, go up a stepp hill or attempt to tow objects. It is best to avoid these circumstances at all times. Power switch doesn’t light up.