How many amps does it take to weld a 6010?
The correct current, or amperage, setting primarily depends on the diameter and type of electrode selected. For example, a 1/8-inch 6010 rod runs well from 75 to 125 amps, while a 5/32-inch 7018 rod welds at currents up to 220 amps.
What is the current setting for root pass?
For root pass welding, the current control should be set as high as necessary while the open circuit voltage (OCV) is set as low as possi- ble, while still permitting the arc to strike without sticking.
Can you run 6010 uphill?
6010 is a fast freeze rod which means the puddle cool and hardens much faster than 7018. This is a technique that will make stick welding in vertical or 6g positions (especially the root pass) much easier to keep from blowing out. …
What is 6010 electrode used for?
Usually, both electrodes are used together in various industrial applications (pipelines welding, storage tanks, etc.). E 6010 is used for welding the joint root-pass for proper penetration, and E 7018 is used for the hot-pass, fill-up, and cap beads.
Why do Welders use 6010 for root pass?
Yes, the 6010 freezes faster. It also burns at a lower temp, so it’s easier to weld with it on an open butt weld joint. This is why I think they use it…but others may have more info on it. I like to run a 3/32″ gap and use a 1/8″ rod. I push the rod in the keyhole far enough that very few sparks come out on me.
Can a pipe root pass be welded uphill?
Sometimes pipe root passes are welded downhill. In fact a lot of downhill welding is done on pipelines under the API welding codes. But the ua-28 pipe welding test is all uphill welding. Both the 6010 root pass and the 7018 fill and cover pass are uphill and welding anything downhill on this test is grounds for failure.
How to weld with an E6010 welding rod?
Techniques On How To Weld with E6010 Rod 1) Whip And Pause To create fuller penetration welding with the 6010 rod , the welder should whip the electrode with 3/32 – 1/2 inch distance and immediately pull in back around 1/8 inch and then “pause” for split of a second to allow the rod to establish the weld puddle on the spot and whip
What kind of pipe to use for root pass?
Please try again later. The UA-28 pipe welding test is a 6 inch schedule 80 pipe done in 6g postion using a 6010 for root pass and a 7018 fill and cap. This video is strictly about the root pass…