How do I fix the lens error on my Canon PowerShot?

How do I fix the lens error on my Canon PowerShot?

9 Answers

1. Remove the batteries and wait a few minutes.
2. Try pressing and holding the Menu, Function, Function Set, or OK while turning on the camera, or otherwise find a “factory reset” option.
3. Try turning the camera on without a memory card inserted.

What does it mean when a Canon camera says lens error?

Lens errors are fairly common. Usually it’s sand or grit interfering with the lens extension mechanism. Or the camera’s been dropped with the lens extended. Or the camera has been powered on, but the lens had been blocked preventing its extension.

How can I fix my camera lens error?

If the lens is stuck partially or fully extended, try gently pulling or pushing the lens barrel as the camera tries to extend or retract it. Usually, a middle section rotates as the lens extends, and you can try gently “helping” it.

How do I reset my Canon camera lens?

I recommend performing a “hard reset” of your camera. To do this, remove the battery pack from the camera then close the battery compartment. Now press and hold down the power button for 5 seconds, then release it. Replace the fully charged battery pack and turn the camera on.

How do I reset my Canon PowerShot?

Resetting Settings to Their Default Values – PowerShot SX150 IS.

1. Turn on the camera and press the button to open the menu.
2. Using the button, highlight the yellow (Set up) tab.
3. Using the button, select [Reset All..] and press .
4. Select [OK] and press .

How do I reset my Canon PowerShot sd1300?

Try removing the batteries from the camera and letting the camera sit without batteries for a few minutes. Then, install fresh batteries and power the camera on. If you still receive the same error message, the camera is going to require service.

How do I know if my camera lens is broken?

If you have the ability to see images produced by a lens or camera body you can look for some things such as dark spots, which may indicate dust or dirt on the lens, or banding which may indicate some deeper malfunction. For a lens, the most common problems show up as poor focus, or uneven focus across an image.

Why does my camera say lens obstruction?

The FZ43 lens is probably jammed or some foreign object(s), dust, dirt, etc., is preventing the lens from functioning properly. Simply power the FZ43 off and restart it to reset the lens. Be sure to check for any particles or other foreign objects around the edges of the lens and carefully clean with a soft, dry cloth.

Can I use alcohol to clean my camera lens?

Yes, you can use alcohol to clean a camera lens. I recommend using 99% Isopropyl Alcohol diluted with distilled water at a ratio of 50/50. Some variants of Isopropyl Rubbing alcohol have less than 99% and include other agents that leave sticky residue on your lenses.