What special protection must be observed when using the motorized miter saw?
What special protection must be observed when using the motorized miter saw outside? Keep the saw covered. Lubricate the saw more often than normal. Unplug the saw after each cut.
What personal protective equipment PPE should be worn at a minimum by a motorized miter saw operator?
Wear a respirator or good quality dust mask when using the motorized miter saw for extended periods. 1. Make a trial cut on a piece of scrap material before attempting final cuts to make sure the saw is cutting properly and that the miter and bevel angles are set accurately. 2.
What is the minimum length of material that can safely be cut on the miter saw?
A saw with a 10-inch blade makes right-angle cuts across a board 5 1/2 inches wide, sufficient for two-by-six lumber. The same 10-inch saw will cut a two-by-four at a 45-degree angle. Manufacturers also make 12-inch versions, which have a maximum cut of about 7 1/2 inches, wide enough for two-by-eights.
When cutting on the miter saw the stock should be placed?
Place the stock against the fence at the back of the saw base, and hold it with your hands (or a clamp) at least 6 inches from the blade. Only then should you start the saw. Always keep your other hand on the saw handle. Both arms should be straight out in front of you, and your feet firmly planted.
What is the standard position of the saw blade on a miter saw?
Miter saw: This cutting tool mimics a hand saw, making it ideal for performing trim work and jobs that require precise measurements. A miter saw blade rotates in a clockwise direction. When installing a new blade, make sure the teeth are pointing downward to enable a clean cut through the workpiece.
Can a miter saw cut a 6×6?
The bevel ranges max out at 45 to 48 degrees. Performance and Cutting Capacity. No saw could cut through a 4×4 at a 45-degree bevel angle, nor could any cross-cut a 6×6.
What is the margin of safety for a miter saw?
6”
Always maintain a 6” margin of safety between all body parts and the blade. Remove chips, scraps and cutoffs only after the blade is at a complete stop. Use clamps or a vice to hold the work-piece in place secure short material without putting your hand in danger.
What are the safety rules of a miter saw?
Miter Saw Safety
- Unplug the saw when you’re changing the blade or not using it.
- Keep your fingers at least 6 in.
- Wear safety glasses and hearing protection when you’re operating the saw.
- Don’t reach under the blade while it’s spinning.
- Let the blade come to a complete stop at the end of each cut before lifting it.
What does dual bevel mean on a miter saw?
Dual-Bevel Compound Miter Saws. The blade angles of a dual bevel miter saw can adjust to both the left and right, as opposed to just one side, like the single bevel saw. Double bevel miter saws allow you to make precise and uniform cuts on both sides of your workpiece.