How does a flow switch work on a pressure washer?
When water flow (GPM) is sensed by the flow switch, it allows the burner to come on, heating the water. This water flow is typically activated by pulling the trigger on the gun. When the trigger is released, the water flow stops, deactivating the flow switch, and turning the burner off.
How do you test a flow switch?
How to Test a Flow Switch
- Put cover on the flow switch and turn power on. Video of the Day.
- Start flow through the designated system.
- Observe flow in operation to determine if flow switch is working properly.
- Repeat this process many times to ensure flow switch and designated system is in fact working accurately. Tip.
How does a water pump flow switch work?
A flow switch operates by conveying a trip motion (relay, reed switch, paddle) to another machine within the system, usually a pump. The trip signal will indicate to the pump to turn on or turn off. It is necessary to provide damage protection and circuit cooling or adjust flow rates that are too high or too low.
What is difference between flow switch and pressure switch?
Pressure Switches are activated when you reach a certain pressure: between 500-700 PSI. When the pressure meets this threshold, the switch is used to activate the burner for hot water. Flow Switches are activated by the recognition of water flow. The pressure is usually lighter, lower than 500 PSI.
How do I know if my flow switch is bad?
”No Flow” light coming on probably means the cell’s flow switch has gone bad. Verify that the pump is running first (water is actually flowing through the line). If “No Flow” stays on the flow switch needs replacing. ”Flow” LED turning from green to red means water flow through the system has been disrupted.
How do you reset a flow switch?
Turn the unit off and unplug it from the power source for 30 seconds. This resets the spa’s control panel and will make the switch work again. If this does not work, turn the unit off again before trying any other troubleshooting techniques.
What causes a flow switch to go bad?
Flow Switches for shower pumps Demand for water to the shower head causes the switch to activate and this, in turn, completes a circuit which tells the pump to begin operating. Over time, shower pump flow switches can degrade due to limescale, heat and other issues, and may eventually need replacing.
What are flow switches?
A flow switch, sometimes referred to as a flow sensor or flow indicator, is a device used to monitor the flow rate and pressure of liquids, air or other gaseous media through a duct, system or loop.
How do you troubleshoot a flow switch?
How to Troubleshoot Flow Switch Operation
- Turn the unit off and unplug it from the power source for 30 seconds.
- Ensure the flow switch valve is open.
- Look at the water level in the hot tub.
- Clean out the filter.
- Check the output pressure and input pressure of the spa’s jets and filter.