Why is my Bunn slush machine not freezing?

Why is my Bunn slush machine not freezing?

Slush Not Freezing Make sure there is at least 20cm clearance around your machine at all times with nothing blocking the fan in particular. Airflow blockage may also be caused by a build-up of dust on the condenser. Your condenser should be cleaned at least once a week with a brush, as shown below.

Why is my slush machine not freezing up?

Often caused by: A blocked or dirty pull-out filter. Insufficient clear space around the machine (at least 30 cm both sides and 10cm at rear)

Why do you need salt in a Slush PUPPiE machine?

Although you may feel like you’re using way too much salt, it doesn’t end up in the finished Slush Puppie. It is used to prevent the mix from freezing.

How do you service a slush machine?

Cleaning Instructions;

1. Turn the slush machine freeze/refrigeration switch to the off position.
2. Drain out any remaining slush.
3. Fill your slush machine with clean, lukewarm water and a suitable mild detergent.
4. After 15 minutes, drain and discard the water, then repeat step 3 with fresh water.

Why does my slush taste of salt?

My slushie tastes of salt! There are two possibilities here – either you’ve put salt in the syrup inlet, or the canister is damaged. Check the ice canister isn’t damaged. If that’s not the culprit then have another go, making extra certain you’re putting the ice and salt into the ice/salt inlet.

How often should you clean a slush machine?

Cleaning Requirement Summary A full clean down, sanitisation and seal lubrication of your slush machine should be carried out every week, or every 500 drinks – whichever is the soonest.

What salt is best for slush machine?

Flip the cap so the open end is face up, then fill it to the brim with table salt. Pour each capful through the inlet hole and into the canister. Although you may feel like you’re using way too much salt, it doesn’t end up in the finished Slush Puppie. It is used to prevent the mix from freezing.

Where is Auger motor on Bunn slush machine?

Common Bunn Slush Machine Repairs. For your convenience, we’ve highlighted some common repairs that service technicians conduct on the Bunn ULTRA slush machines. Replacing an Auger Motor. The auger motors in an ULTRA-1 and ULTRA-2 slush machine are at the upper rear of the dispenser chassis inside the auger motor covers.

Where can I find a Bunn slush machine?

The ULTRA-1 and ULTRA-2 machines are found in many convenience stores, restaurants and foodservice establishments, and most customers call on service technicians. Below are common maintenance projects and a link to service manuals featuring all Bunn slush machine repair tasks. NOTE: This guide is only for authorized technicians.

What causes a leak on a slush machine?

Let’s dive in to some slush machine troubleshooting… If your machine is leaking, the first step is to work out where the leak is coming from. This will determine how to fix the leak. If the leak is coming from the tap, on your slush machine, the cause is usually a stiff tap or damaged seals.

How to set up the Bunn ultra Auger?

Add 5 parts water 1 one part concentrate to mixing jug. Shake and pour into Hopper (s). Power on Bunn Ultra. Press Auger button to activate auger. Press temperature button and set to “ICE” Read and follow the BUNN ULTRA Installation & Operating Guide included with your kit.