What does a PNP transistor do?

What does a PNP transistor do?

PNP transistors are used to source current, i.e. current flows out of the collector. PNP transistors are used as switches. These are used in the amplifying circuits. PNP transistors are used when we need to turnoff something by push a button.

How can I use PNP as a switch?

For a PNP transistor, the Emitter potential must be positive with respect to the Base. Then the transistor operates as a “single-pole single-throw” (SPST) solid state switch. With a zero signal applied to the Base of the transistor it turns “OFF” acting like an open switch and zero collector current flows.

How do transistors work as a switch?

One of the most common uses for transistors in an electronic circuit is as simple switches. In short, a transistor conducts current across the collector-emitter path only when a voltage is applied to the base. When no base voltage is present, the switch is off. When base voltage is present, the switch is on.

How do I know which transistor to use?

The device switched by the transistor is called the load. When choosing a transistor to use as a switch you need to consider its maximum collector current Ic(max) and its minimum current gain hFE(min). Transistor voltage ratings may be ignored for supply voltages less than 15V.

What is a PNP switch?

PNP = Switched Positive. NPN = Switched Negative. “Switched” refers to which side of the controlled load (relay, small indicator, PLC input) is being switched electrically. Either the load is connected to Negative and the Positive is switched (PNP), or the load is connected to Positive and the Negative is switched (NPN …

How a transistor works as a switch?

How do I convert PNP to NPN?

If you have the exact NPN equivalent you only need to mount the circuit as it is drawn, so that the base, collector and emitter terminals of the NPN are connected where base, collector and emitter of the PNP should go, and then reverse the power supply polarity.

When a transistor is used as a switch it operates between?

Transistors may be used as switching elements to control DC power to a load. The switched (controlled) current goes between emitter and collector; the controlling current goes between emitter and base. When a transistor has zero current through it, it is said to be in a state of cutoff (fully nonconducting).