Are there different size drain traps?
Traps are made from polypropylene (white or black), ABS (black), PVC (white) or brass (either chrome-plated or natural colored). Traps come in 1-1/4 inch (standard bathroom sink) or 1-1/2 inch (standard kitchen sink) inside diameter sizes. Be sure to check so you get the right size replacement at your local store.
Do all drains need a trap?
Because of its shape, the trap retains some water after the fixture’s use. This water creates an air seal that prevents sewer gas from passing from the drain pipes back into the building. Essentially all plumbing fixtures including sinks, bathtubs, and showers must be equipped with either an internal or external trap.
What is a drain trap in plumbing?
A plumbing drain trap is designed to retain a small amount of water each time the sink drains, and this water standing in the bottom of the curved portion of the trap seals the drain and keeps sewer gasses from escaping the drain and entering your home. …
How far below drain should P trap be?
When designing a house, it can be hard to determine how far below the drain a P-trap should be. The P-trap should be located no more than 24” below the drain.
How do I know what size P trap to buy?
If you have 2.5 inches from the bottom of the tailpiece to shelf and 0.5 inches from the drain to shelf you can use CP-trap. First you have to cut 2.5-2.0 inches from the end of the tailpiece. The height of the p-trap is 4.5 inches 5-2.5=2.5 inches or 4.5-2.5=2.0 inches.
How far can a trap be from a drain?
According to the International Residential Code, the maximum vertical distance between the sink drain and the entrance to the p-trap is 24 inches.
Why are S-traps bad?
S-traps are no longer used in modern plumbing because the water can be sucked completely out of the trap allowing sewer gas to enter your home. The risk from sewer gas can be much worse than just that terrible smell, as sewer gases can be poisonous or explosive.
Why are S-traps not allowed anymore?
The “S” trap is prohibited under the Uniform Plumbing Code throughout the United States. This is because the “S” trap will siphon or suck water out from the trap which will end up releasing methane (sewer) gases into the home. So, it is a code violation and if you are doing remodeling, you will have to replace it.
Where is a trap located?
A trap is a U shaped pipe located under sinks, tubs, shower, washing machines, and pretty much anything that connects to your sewer line system. They can be seen quite easily, just open up the cabinet under the sink in the kitchen or look at the side of the toilet.
Does P-trap have to be directly under shower drain?
If you install TWO “P” traps the shower will NOT drain. The “P” trap SHOULD be directly under the drain, but no more than a few inches off center of it, if conditions require it. NO trap, TWO traps, and/or a 9 foot offset are NOT allowed and if he suggests any of them get a different installer who is a REAL plumber.