How do you use EIGRP protocol?

How do you use EIGRP protocol?

EIGRP Configuration Step by Step: a cisco packet tracer lab

1. Step1: Assign ip addresses on Router Interfaces as well as PC’s as mentioned in topology diagram.
2. Step 2: EIGRP configuration on R1:
3. Step 3: EIGRP Configuration on R2:
4. Step 4: EIGRP Troubleshooting command.
5. Check Routing Protocol on R1 Router for EIGRP:

How do I find my EIGRP configuration?

show ip eigrp interfaces Command Output. The show ip eigrp interfaces command displays information about interfaces configured for EIGRP. This output includes the following key elements: Interface—Interface over which EIGRP is configured.

Which is better OSPF or EIGRP?

EIGRP vs OSPF: Scalability. The scalability of the OSPF is higher than EIGRP because EIGRP is complicated and vendor-specific and incapable of migrating from one vendor to the other. Conversely, OSPF is an open standard and simple protocol through which the network can be scaled easily.

Is EIGRP removed from CCNA?

The following topics have been removed from the CCNA curriculum: Network fundamentals – OSI model. LAN Switching – Frame, VTP, Switch stack. Routing – EIGRP, RIPv2, OSPFv3, Inter-VLAN routing.

What devices run using EIGRP?

EIGRP is used on a router to share routes with other routers within the same autonomous system. Unlike other well known routing protocols, such as RIP, EIGRP only sends incremental updates, reducing the workload on the router and the amount of data that needs to be transmitted.

How do I configure RIP routing?

Configuring RIP requires the following steps:

1. Step 1 Enable the RIP routing process, which places you in router configuration mode via the Router#router rip command.
2. Step 2 Specify those networks that should be advertised using RIP via the Router(config-router)#network [network-number] command.

How do I troubleshoot verify EIGRP configuration?

The following three commands are used to verify and troubleshoot EIGRP:

1. show ip route.
2. show ip protocols.
3. show ip eigrp neighbors.
4. show ip eigrp topology.
5. debug eigrp packets and debug ip eigrp notifications.

How to enable EIGRP from global configuration mode?

Enable EIGRP routing protocol from global configuration mode. Tell EIGRP which interfaces we want to include. For these steps following commands are used respectively. This command will enable EIGRP routing protocol in router. We can use any ASN (Autonomous System Number) from 1 to 65,535.

What do you need to know about Cisco EIGRP?

Configuring Basic EIGRP. EIGRP is an extremely common routing protocol due to its simplicity and ease of configuration. This lab will discuss and demonstrate the configuration and verification of the Cisco EIGRP dynamic routing protocol.

Can you use EIGRP on a Juniper router?

EIGRP is a Cisco proprietary routing protocol which means its only found on Cisco equipment. You cannot run EIGRP on Juniper or Adtran or any other router for that matter since EIGRP is special (only to Cisco).

Why is EIGRP the most common routing protocol?

EIGRP is an extremely common routing protocol due to its simplicity and ease of configuration. This lab will discuss and demonstrate the configuration and verification of the Cisco EIGRP dynamic routing protocol.