How do I enable IP routing on a Cisco 2960 switch?
To enable routing we need two things. Firstly activate the functionality sdm prefer lanbase-routing and subsequently enable ip routing. You need to reload for the change to take place. After the system reload, you can use the show sdm prefer command to verify the change.
Does ip route show command?
To display the current state of the routing table, use the show ip route command in user EXEC or privileged EXEC mode. The show ip route command is a powerful tool to use at this point in your search. You can directly examine the routing table to determine if an entry for the host exists.
How do I show the routing table on a Cisco router?
On a Cisco router, the show ip route command is used to display the IPv4 routing table of a router.
What is the default IP address of Cisco 2960?
10.0.0.1
The switch has a default IP address “10.0. 0.1” and a secondary IP address “10.0. 0.3”. 2 Enter a Hostname.
How do I find the IP address of my Cisco switch?
Perform a show mac address-table interface on the switch that has the device(s) connected to it. Then go to the router for the VLAN specified in the previous command and perform a show ip arp vlan | include . That will give you the IP address for the device.
How do I enable IP routing on a switch?
To enable IP routing, use the ip routing command in switch configuration mode. To disable IP routing, use the no form of this command. This command has no arguments or keywords. IP routing is disabled.
How many routes can a Cisco 2960 CX switch support?
The switch supports 16 static routes (including user-configured routes and the default route) and any directly connected routes and default routes for the management interface. You can use the “lanbase-default” SDM template to configure the static routes. The switch can have an IP address assigned to each SVI.
Where can I find catalyst 2960 switch command reference?
Catalyst 2960 Switch Command Reference Corporate Headquarters Cisco Systems, Inc. 170 West Tasman Drive San Jose, CA 95134-1706 USA http://www.cisco.com Tel: 408 526-4000 800 553-NETS (6387) Fax: 408 526-4100 Catalyst 2960 Switch Command Reference
How to enable or disable IP routing in Cisco switch?
Configure static routes. By default, the switch is in Layer 2 switching mode and IP routing is disabled. To use the Layer 3 capabilities of the switch, you must enable IP routing. Enters global configuration mode.
How does Cisco router work with static routing?
The router checks the routing table, finds the correct outgoing interface, and forwards the packet on the VLAN 20 interface to Switch B. Switch B receives the packet and forwards it to Host C. When static routing is enabled on Switch A and B, the router device is no longer needed to route packets.