What ingredients are in Dentemp?

What ingredients are in Dentemp?

Ingredients. Dentemp: Calcium Sulfate, Barium Sulfate, Dimethoxytetraethylene Glycol, Zinc Oxide, Eugenol, Ethylmethacrylate Polymer.

How long does temporary tooth cement last?

The temporary crown needs to be removed in 1 to 3 weeks, and thus the weak temporary cements may occasionally fail before your scheduled follow-up visit. Patients should be careful to avoid chewing sticky substances like candy and gum and exert caution when flossing near the temporary crowns.

How do I use maximum strength in Dentemp?

Place a very small amount of Dentemp along the inside edge of the open end of the crown. Place crown on wet tooth and press firmly. Bite down several times to insure proper fit. If the bite is not completely comfortable, remove and repeat all steps until the crown feels normal.

Should I use temporary dental cement?

A temporary filling is an excellent way to protect a damaged tooth as you wait for a permanent filling. Temporary fillings aren’t meant to last, so be sure to schedule a follow-up appointment with your dentist to receive a permanent filling. This can protect your tooth from further decay and infection.

How is dentemp used for lost fillings and caps?

Dentemp is clinically proven to temporarily repair loose caps and crowns and replace lost fillings, while providing instant pain relief. Dentemp the #1 selling over the counter dental cement was developed by a dentist. It is easy to use, and the formula is safe and strong, so you can eat on it in just 60 minutes.

Is it safe to eat on dentemp loose cap?

It is easy to use, and the formula is safe and strong, so you can eat on it in just 2 hours. If you can’t get to the dentist, get Dentemp. Dentemp Loose Cap & Lost Filling Repair provides fast relief of pain and discomfort until you can see your dentist.

Can you use dentemp on dental implants?

Dentemp Premium Dental Repair should not be used on implants or posts without dentist’s advice. Ingredients: Calcium Sulfate, Barium Sulfate, Dimethoxytetraethylene Glycol, Zinc Oxide, Eugenol, Ethylmethacrylate Polymer.

When to use dentemp o.s.when replacing a bridge?

Allow at least 1 hour to set before eating.Note: when replacing a bridge apply Dentemp® O.S. sparingly to only 1 hollow tooth at each end of the bridge. Dentemp® O.S. should not be used on implants or posts without dentist’s advice.Store at room temperature with container closed to keep material soft.