Are 1JZ and 2JZ water pumps the same?

Are 1JZ and 2JZ water pumps the same?

The 1JZ-GTE in the Soarer uses the same water pump as the 2JZ-GTE in the JZA80 Supra. (It’s the same part number).

What is the labor cost to replace a water pump?

The average water pump replacement cost is $550, with prices ranging from $461 to $638 in the US in 2020. But typically depends on the type of vehicle you drive and the auto repair shop you take it to. Labor costs are between $256 and $324 while parts cost between $205 and $314. Estimate doesn’t include fees and taxes.

How much does it cost to replace BMW water pump?

BMW 328i Water Pump Replacement Cost Estimate. Labor costs are estimated between $267 and $337 while parts are priced between $409 and $552. This range is based on the number and age of BMW 328i’s on the road.

Does 1JZ fit 2JZ parts?

You will need a 1JZ bellhousing and flywheel which can be used on the 2JZ too. The clutch system is the same that comes from a turbo MKIII with a R154. You will needs special brackets to allow you to swap your 1JZ/2JZ into your car.

How long should a water pump last?

60,000 to 90,000 miles
The average lifespan of a water pump is similar to the lifespan of a timing belt. They usually last 60,000 to 90,000 miles with the proper care. However, some cheaper water pumps may begin leaking at as low as 30,000 miles.

How long do BMW water pumps last?

About Water Pump Replacement A failing water pump can also leak causing further loss of coolant. Water pumps are designed to last at least 100,000 miles, however, if your water pump fails, you should replace it with a high-quality original-equipment level unit.

Where can I get a Toyota 2JZ GTE water pump?

You can get the Toyota 2JZ-GTE water pump with the rear housing and new O-ring from Curt at Elmhurst Toyota or your Toyota dealership. It will eliminate the hydro pump setup and allow you to run a simple fan and fan clutch setup.

Can a water pump be used on a JDM 1JZ GTE?

This pump can be used as replacement water pump on a US or JDM 1JZ-GTE or 2JZ-GTE, and can eliminate the hydrofan water pump on a 1JZ or 2JZ JDM engine. This is a complete water pump assembly, with the rear housing.

What do I need to swap a 1JZ GTE for a 2JZ?

Below are all the parts listed for a 1JZ-GTE or a 2JZ-GTE swap. You will need the motor set and all of its electrical parts. Certain things will need to be changed for fitment and simplicity such as the oil pan and water pump. You will need a 1JZ bellhousing and flywheel which can be used on the 2JZ too.

Can you swap 1JZ / 2JZ twin fuel pump?

You will needs special brackets to allow you to swap your 1JZ/2JZ into your car. Intercooler piping will be custom to any swap but there are “plug and play” piping kits for 1JZ/2JZ twin setups. You should upgrade to the higher flow Walbro fuel pump as it will support the higher boost levels a lot better than the stock pump.