What is Webauth Cisco?

What is Webauth Cisco?

Web Authentication or Web Auth is a layer 3 security method that allow client to pass DHCP & DNS traffic only untill they have passed some form of authentication. WLC has four authentication policies.

What is a FlexConnect ACL?

FlexConnect Access Control Lists An access control list (ACL) is a set of rules used to limit access to a particular interface (for example, if you want to restrict a wireless client from pinging the management interface of the controller). ACLs enable access control of network traffic.

What is FlexConnect local authentication?

local authentication, local switching—In this state, the FlexConnect access point handles client authentication and switches client data packets locally. This state is valid in standalone mode and connected mode.

How do I add WLC to ISE?

In order to add WLC as a network device on the ISE, navigate to Administration > Network Resources > Network Device Groups > All Device Types, create a new group for WLC, as shown in the image: Step 4. Add WLC as a Network Device. Navigate to Work Centers > Device Administration >Network Resources > Network Devices.

How many AP groups are there in FlexConnect?

A FlexConnect group can have a maximum of 100 APs on Cisco 7510 Controller, and 25 APs on Cisco 5508 Controller. A FlexConnect group can have one primary AP per AP model.

What is FlexConnect AP mode?

FlexConnect is an AP mode for situations like the one above. The AP can locally switch traffic between a VLAN and SSID when the CAPWAP tunnel to the WLC is down.

Is there support for external web authentication in WLC?

Before WLC Release 7.2.110.0, the Web Authentication to an external server was supported for APs in Local mode or FlexConnect mode for WLANs with centrally switched traffic (FlexConnect – Central Switching).

Do you need web authentication with flexconnect local?

For the WLAN level, click the Over-ride Global Config checkmark and insert the URL. At the global level, go to Security > Web Auth > Web Login Page: Web Authentication (internal or to an external server) requires the Flex AP to be in Connected mode. Web Authentication is not supported if Flex AP is in Standalone mode.

Can a WLC support flexconnect APS in local switching mode?

This document describes how to configure central web authentication with FlexConnect Access Points (APs) on a Wireless LAN Controller (WLC) with Identity Services Engine (ISE) in local switching mode. Important Note: At this time, local authentication on the FlexAPs is not supported for this scenario.

Where to apply flexconnect ACL in WLAN?

Considering a WLAN configured for Web Authentication and for local switching, the logic behind this feature is to distribute and apply the Pre-Authentication FlexConnect Access Control List (ACL) directly at the AP level instead of the WLC level.