Why is my Kohler engine surging?

Why is my Kohler engine surging?

surging on a governed engine is always due to an fuel;air ratio that is too low. The fuel supply to the main jet is not enough. You test for the first by starting the engine and saturating the area between the carb & the engine with WD 40 or similar from a trigger pack, not a spray can.

Why is my Husqvarna lawn mower surging?

The most common reason for a surging lawn mower engine is a blockage in the fuel supply, but there are other possibilities: Bad gas. Bad spark plug. Dirty / faulty carburetor.

Why does my lawn mower keep surging?

Problems in the Fuel System Check and clean the vent. Surging is also caused by water that got into the fuel. A mower left in a heavy rain or condensation on a hot summer day can choke the engine. Empty the gas tank, properly dispose of the old fuel and try a fresh batch of gasoline.

What causes a carbureted engine to surge?

Incorrect fuel mixture adjustments and engine idling capabilities can be upset by fuel mixture adjustments and fuel vapor recovery system malfunction. The fuel system cleaner added to the fuel tank can open blocked passages in the fuel system that could be causing the surge.

Why does my push mower rev up and down?

Airflow Issues. A lawnmower that hunts and surges may be experiencing something as simple as an airflow issue. If the air that the engine requires to run is blocked, especially sporadically, it can cause the engine to slow down. When the blockage moves or clears, the engine may suddenly rev up in response.

Why is my engine revving up and down?

If the engine can’t keep idling, it will keep trying to get the engine revved up to compensate. The cause of the erratic engine you’re experiencing could be a vacuum leak, sensor failure, or an EGR system malfunction.

Why is my mower revving up and down?

A carburetor that’s incorrectly adjusted is a common cause of poor engine idling that results in hunting and surging. Fortunately, most lawnmowers have two screws that allow you to adjust the carburetor yourself. Then slowly adjust the screws tighter or looser in turn until the mower runs and idles smoothly.

Begin typing your search term above and press enter to search. Press ESC to cancel.

Back To Top