How do you program on Concord 4?

How do you program on Concord 4?

To enter program mode: Press 8, 4321, 0, 0. The display shows SYSTEM PROGRAMMING.

How do I get my Concord 4 to stop beeping?

Press the * (STATUS) button or arm/disarm the system to silence the beeps. They will resume after four hours unless the problem has been corrected.

How many user codes can the Concord 4 support?

SuperBus 2000 2-Amp Power Supply (600-1019) Q. How many touchpads can the Concord 4 handle? A. The Concord 4 can handle up to 16 bus devices, which include touchpads, keep in mind the system many require a power supply if multiple touchpads are used.

How do you turn on the chime on a Concord 4?

Chime Mode When activated, two beeps will sound at the keypad whenever a door or window is opened. To enable or disable the Chime feature, Press 7 + 1 – chime turns on/off.

How many zones does a Concord 4 have?

8
Zone Groups are pre-programmed for the 8 hardwired zones. 1. Entry Exit Delay – For Doors that require a delay for entry or exit 2. Instant Interior Follower – For motion detectors that will arm instantly.

How do I bypass Concord zone?

1. Close all doors and windows.
2. Arm your system in STAY or AWAY mode.
3. Press # + CODE.
4. The keypad will display “BYPASS SENSOR _ _”, enter the sensor you wish to bypass.
5. The keypad will display “BYPASSED ZONE _ _” or “SENSOR _ _ BYPASSED”.

How many wireless zones does a Concord 4 have?

Each receiver supports all (96) wireless zones. Increase the power capability for system peripherals with a SuperBus 2000 power supply module with battery backup.

How do I clear the memory on my Concord 4?

To begin this process, press the “asterisk” key. While the keypad begins displaying status updates, press the “disarm” button followed by your 4-digit alarm code. This will clear the system memory and prevent the system from displaying the same message again for 4-10 hours.

How do I reset my Concord 4?

How To: Reset Installer Code Concord 4

1. unplug alarm from outlet.
2. locate eprom.
3. remove eprom.
4. wait 2 minutes.
5. can verify as keypad will do nothing by trying options.
6. plug prom back in.
7. plug power back in.