Is a spindle and hub assembly the same?
The spindle is part of the hub and is technically the part with the spline shaft that protudes thru the bearings and is clinched by the 30mm nut.
Will Dana 50 TTB hubs fit a Dana 60?
The Dana 50 brake parts/spindle etc are compatible with the ’95-97 Dana 60 knuckle. Been there, done that.
How do you tell the difference between a Dana 50 and a Dana 60 front axle?
Look for a number on the lower right of the sticker. If it’s a 229 it will be a Dana 50 and if it’s 248 it’s a Dana 60.
What does a spindle hub do?
When you’re towing, spindles are the part of the trailer axle assembly that the wheel hubs (and wheels) rotate around. Trailer spindles provide a surface for the inner and outer wheel bearings to roll on — or rather, to roll around. In other words, the spindles are literally at the center of it all.
Do I need to replace the hub assembly or just the bearing?
Your wheel bearing may have been damaged slightly in the past and has now worn to the point it is starting to make noise. Your mechanic is correct in that the only repair for the bearing is to replace the hub. It is a sealed unit and cannot be disassembled without destroying it.
What is a Dana 60 rear end?
The Dana/Spicer Model 60 is an automotive axle used in OEM applications by Chevrolet, Dodge, Chrysler, and Ford. There are rear axle and four wheel drive front steering versions of the Dana 60. It can be readily identified by its straight axle tubes, 10 bolt asymmetrical cover, and a “60” cast in to the housing.
Is the Dana 50 a good axle?
In fact, the Dana 50 and 60 high-pinion Super Duty axles have more in common than you might realize. As you may infer from its name, the Dana 50s overall size and strength rest between that of a Dana 44 and Dana 60. For those looking to run up to a 37-inch tire, the Dana 50 is well-suited.
How big is the flange on a Dana 60 wheel?
Description: DANA SPICER REFERENCE PART # 700022 Manufactured by ECGS Fits all Ford 92 and Earlier Dana 60 Spindle and some later check flange width late spindle has 7″ Flange: * 7″ Long * 6.5″ Flange… More Details » Description: DANA SPICER PART # 700014 Dana 60 Spindle Bearing and Seal Kit Includes: Bearing, two Seals and Thrust Washer.
Is the Dana 61 front axle a Chevy hub?
The 90-93 versions had internal style hubs just like the Chevy and lockout hubs. One caution with dodge applications, is you have to be careful to avoid the Dana 61 front axle. 1987-88 and 1991-93.5 Dodge D600 and D700 also came with Dana 61.
Can a Dana 60 have a kingpin axle?
Later model Ford high pinion (HP) Dana 60s with balljoints instead of kingpins are also desirable axles, though many prefer the kingpin knuckles over the balljoints. The undesirable front Dana 60 axles will not be covered by this article, and include:
What are the parts of a stage 8 spindle nut?
Description: Stage 8 Locking Spindle Nut is comprised of 5 parts; a thrust washer, a specialized notched washer, the spindle nut (which can be set to an individual pre-load value), a locking retainer and a… More Details » Limited Supply: Only 6 Left! Description: This is a complete weld on kit to upgrade your rear drum brakes to disc brakes.