Why is my Horizon Fitness treadmill not working?

Troubleshoot non-functioning console keys by unplugging the treadmill and firmly massaging all console keys with a circular motion. Plug the treadmill back in and check the keys. If they still don’t work, unplug the treadmill and wait 60 seconds for all energy to discharge.

How do I reset my horizon treadmill?

Press and hold the “Stop/Pause” button for at least 3 seconds to reset the treadmill. You will hear a beeping noise, which indicates the treadmill has been reset. Release the “Stop/Pause” button.

Where is the reset button on a true treadmill?

The reset button is located on the front left hand side of the base of the treadmill, if you are standing in front of the machine. It is on the right side if you are standing on the walking belt facing the display.

How do you fix a treadmill that won’t turn on?

If the electrical outlet works, unplug the treadmill and check the power cord for damage. Replace the power cord if it’s damaged. If the power cord is okay, check the circuit breaker switch on the treadmill and reset the circuit breaker switch if it’s tripped.

How do you troubleshoot a Horizon treadmill?

No console display.

Unplug treadmill from wall outlet. Wait 60 seconds, allowing lower board to discharge built up energy.
Check power cord for pinches or crimps.
Verify that the treadmill is on a dedicated 15-amp circuit. CONTACT AN ELECTRICIAN TO VERIFY IF NECESSARY.

Why does my treadmill belt not move?

If the belt is too tight, it could cause enough tension that the motor can’t turn the belt. This is most likely the cause of your belt not moving if you recently adjusted the belt tension due to slippage. If you can’t raise it at least 2 to 3 inches off the walking deck, the belt is too tight.

Why did my treadmill stop working?

Treadmills require lubrication to limit the amount of friction between the platform and belt. When the friction increases to a certain point, the machine is automatically set to power off. This may be the cause for the machine to stop working suddenly. Try lubricating the belt.

Why do treadmills stop working?

Why does my treadmill not start?

Loose or broken parts under the motor hood of your treadmill can cause the machine to not start. If the console lights up, but the treadmill won’t start, the motor controller could be damaged. Loose wires under the motor hood or in the console can cause your treadmill not to start.

Why does treadmill say error?

An E1 code just means that the console is not getting a reading from the reed switch (Speed Sensor). If the running belt moves for several minutes and then produces the E1 error, this is most commonly a result of the running belt needing lubrication. When this occurs, the running belt can no longer absorb lubrication.

How to troubleshoot the horizon treadmill console keys?

Are there any problems with the horizon treadmill?

Many consumers of Horizon Fitness Treadmill have reported that their console have some problems after some time. Solution-Actually the problem arises in the display of the console panel.

What to do if your horizon fitness machine is tripped?

CONTACT AN ELECTRICIAN TO VERIFY IF NECESSARY. Find the power control box for outlet and verify that specified circuit has not been tripped. CORRECTIVE ACTION: If the circuit breaker is tripped, reset breaker and try machine again. If breaker trips again, contact the retailer where you purchased the machine.

What to do if your treadmill is not working?

Reinsert the safety key in the console. If you see all dashes or “safety key off” displayed on the treadmill console before removing the key, this may solve the problem. Troubleshoot non-functioning console keys by unplugging the treadmill and firmly massaging all console keys with a circular motion. Plug the treadmill back in and check the keys.